How long does steak take to cook in oven depends on three main things: the thickness of your cut, how well done you want it, and whether you sear it first on the stovetop. A one-inch ribeye might need only 8 to 10 minutes at 450°F, while a thick two-inch filet can take closer to 20 minutes. This guide breaks down the timing so you can pull a perfectly cooked steak every time.
The good news is that oven cooking gives you steady, even heat. You do not need to babysit a skillet or worry about flare-ups. Once you know the basic timing chart, it becomes a repeatable skill.
How Long Does Steak Take To Cook In Oven
Here is the short answer. For a one-inch steak cooked at 400°F to 450°F, plan on 7 to 10 minutes for medium-rare. That assumes you flip it once halfway through. Thicker cuts need more time, thinner cuts need less.
Use this quick reference table as your starting point. Times are for a steak brought to room temperature before cooking.
- 1 inch thick, medium-rare: 8 to 10 minutes
- 1 inch thick, medium: 10 to 12 minutes
- 1.5 inches thick, medium-rare: 12 to 15 minutes
- 1.5 inches thick, medium: 15 to 18 minutes
- 2 inches thick, medium-rare: 18 to 22 minutes
- 2 inches thick, medium: 22 to 26 minutes
Always check internal temperature with a meat thermometer. That is the only reliable way to know doneness. Time is just a guide.
Target Internal Temperatures For Doneness
Pull your steak about 5°F before it reaches the target. Carryover cooking will finish the job while it rests.
- Rare: 120°F to 125°F
- Medium-rare: 130°F to 135°F
- Medium: 140°F to 145°F
- Medium-well: 150°F to 155°F
- Well done: 160°F and above
Does Searing First Change The Cooking Time
Yes, and this trips up a lot of home cooks. If you sear the steak in a hot pan for 2 to 3 minutes per side, you add about 4 to 6 minutes of total cook time before the oven even starts. But the oven time itself drops.
A reverse sear works the other way. You bake low and slow first, then sear at the very end. In that case, oven time goes up to 30 to 45 minutes at 250°F, but the final sear takes only 60 to 90 seconds per side.
Pick one method and stick with it. Mixing up the order without adjusting your timing is how steaks end up overcooked.
Step-By-Step Oven Steak Method
This is the sear-then-oven approach. It is the fastest route to a steakhouse-style crust with a juicy center.
- Take the steak out of the fridge 30 to 40 minutes before cooking. Pat it very dry with paper towels.
- Season both sides generously with salt and black pepper. Add a little garlic powder if you like.
- Preheat your oven to 425°F. Place a cast iron skillet or oven-safe pan inside while it heats.
- Move the hot pan to the stovetop over high heat. Add a thin layer of oil with a high smoke point.
- Sear the steak for 2 minutes per side without moving it. You want a deep brown crust.
- Add a knob of butter and a sprig of thyme or rosemary if you have them. Spoon the melted butter over the steak.
- Transfer the whole pan to the oven. Cook for the time listed in the chart above, flipping once at the halfway point.
- Check the internal temp about 2 minutes before your estimated finish time. Thermometers beat guesswork.
- Rest the steak on a cutting board for 5 to 10 minutes. Slice against the grain.
Tips For Better Results
- Dry surface equals better crust. Moisture steams the meat instead of browning it.
- Do not overcrowd the pan. Two steaks max in a standard skillet.
- Let the pan get properly hot before the steak touches it.
- Resting is not optional. Cutting too early lets the juices run out.
- Thinner steaks under one inch cook fast. Stay close to the oven.
Common Mistakes To Avoid
One big mistake is cooking straight from the fridge. A cold center throws off every timing estimate you read online. Give the meat time to lose its chill.
Another is skipping the thermometer. Poking the steak with your finger works for grill veterans, but it is unreliable in an oven. A cheap instant-read thermometer costs less than a single steak dinner.
Finally, do not crank the heat past 450°F for thick cuts. The outside burns before the inside cooks. Lower temps and a bit more patience give you a more even result.
Frequently Asked Timing Questions
These come up often, so here are straight answers.
Can I Cook Steak In The Oven Without Searing
Yes. Skip the stovetop and bake at 400°F for 10 to 14 minutes for a one-inch steak, flipping once. The crust will be softer, but the inside cooks just fine. This is a good option for thinner cuts that overcook easily in a hot pan.
What Temperature Should The Oven Be
Use 400°F to 450°F for the sear-first method. Use 225°F to 275°F for a reverse sear or slow roast. High heat for speed, low heat for control.
How Do I Know When It Is Done
Use an instant-read thermometer inserted into the thickest part, away from bone and fat. Compare the reading to the doneness chart above. That is it.
Does Bone-In Steak Take Longer
Bone slows heat transfer a little, so add roughly 2 to 3 minutes to the total time. The bone also insulates one side, so rotate the steak once during cooking for even results.
Once you cook two or three steaks this way, you will stop counting minutes and start trusting the thermometer. That is when oven steak becomes easy.